Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

description

Enter a description of the RIP routing protocol.

S4048–ON

Syntax
description {description}

To remove the description, use the no description {description} command.

Parameters
description
Enter a description to identify the RIP protocol (80 characters maximum).
Defaults
none
Command Modes
ROUTER RIP
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0)
Introduced on the S3048-ON and S4048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.8.1.0
Introduced on the S-Series.
7.6.1.0
Introduced on the C-Series.
pre- 7.7.1.0
Introduced on the E-Series.
Related Commands
  • router rip — enters ROUTER mode on the switch.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\