Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

dot1x host-mode

Enable single-host or multi-host authentication.

Syntax
dot1x host-mode {single-host | multi-host | multi-auth}
Parameters
single-host
Enable single-host authentication.
multi-host
Enable multi-host authentication.
multi-auth
Enable multi-supplicant authentication.
Defaults
single-host
Command Modes
INTERFACE
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000–ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
9.0.0.0
Introduced on the Z9000.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.3.11.1
Introduced on the Z9000.
8.4.1.0
Added the multi-auth option on the C-Series and S-Series.
8.3.2.0
Added the single-host and multi-host options on the C-Series, E-Series, and S-Series.
Usage Information
  • Single-host mode authenticates only one host per authenticator port and drops all other traffic on the port.
  • Multi-host mode authenticates the first host to respond to an Identity Request and then permits all other traffic on the port.
  • Multi-supplicant mode authenticates every device attempting to connect to the network on the authenticator port.
Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\