Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

dot1x port-control

Enable port control on an interface.

Syntax
dot1x port-control {force-authorized | auto | force-unauthorized}
Parameters
force-authorized
Enter the keywords force-authorized to forcibly authorize a port.
auto
Enter the keyword auto to authorize a port based on the 802.1X operation result.
force-unauthorized
Enter the keywords force-unauthorized to forcibly de-authorize a port.
Defaults
None
Command Modes
Auto
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000–ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
9.0.0.0
Introduced on the Z9000.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.3.11.1
Introduced on the Z9000.
7.6.1.0
Introduced on the C-Series and S-Series.
7.4.1.0
Introduced on the E-Series.
Usage Information
The authenticator completes authentication only when you set port-control to auto.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\