Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

dynamic-auth-enable

Configure NAS to receive and process dynamic authorization messages.

Syntax
dynamic-auth-enable

To stop NAS from receiving and processing dynamic authorization messages, use the no dynamic-auth-enable command.

Defaults
Disabled.
Command Modes
  • CONF-DYNAMIC-AUTH
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

The following is a list of the Dell EMC Networking OS version history for this command.

Version
Description
9.14(1.0)
Introduced on the S4810 and S4820T.
9.13(0.0)
Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000, S6010–ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and MXL.
Usage Information
If this configuration is not enabled, then dynamic authorization messages are not handled by the NAS.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\