Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

enable

Enable all activities and severs for the SupportAssist service.

Syntax
enable all

To disable the SupportAssist activities temporarily, use the no enable all command.

Parameters
all
Enter the keyword all to enable all SupportAssist service activities.
Defaults
Enabled or All Enabled
Command Modes
SUPPORTASSIST
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.11(0.0)
Introduced on the M I/O Aggregator and FN IOM.
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the C9010, Z9100–ON, S6100–ON, and S3100 series.
9.9(0.0)
Introduced on the S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000, S6000–ON, Z9500, MXL.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\