Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

errdisable recovery cause

Enable automatic recovery of an interface from the Err-disabled state.

Syntax
errdisable recovery cause {bpduguard | fefd | maclearnlimit | arp-inspection}

To disable the automatic recovery, use the no errdisable recovery cause {bpduguard | fefd | maclearnlimit | arp-inspection} command.

Parameters
bpduguard
Enter the keyword bpduguard to enable the timer to recover the interface from BPDU Guard error.
fefd
Enter the keyword fefd to enable the timer to recover the interface from FEFD error.
maclearnlimit
Enter the keyword maclearnlimit to enable the timer to recover the interface from MAC learning limit error.
arp-inspection
Enter the keyword arp-inspection to enable the timer to recover the interface from an arp-inspection error.
Defaults
Disabled
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.14(1.0)
Introduced arp-inspection option.
9.14(0.0)
Introduced on the platforms S4048–ON, S6100–ON, Z9100–ON, S4048T-ON, S3048–ON, S6000, S6010–ON, S5048F-ON, FN-IOM and MXL.
9.13(0.2P2)
Introduced on the S3100.
Usage Information

This command has to be configured before the interface moves to Err-disabled state. If not, the recovery action is not performed.

Related Commands
errdisable recovery interval— Configure recovery timer interval for an interface.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\