Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

Far-End Failure Detection (FEFD)

The Dell EMC Networking operating software supports far-end failure detection (FEFD) on the Ethernet interfaces of the platform.

The FEFD feature detects and reports far-end link failures.
  • FEFD is not supported on the Management interface.
  • During an RPM failover, FEFD is operationally disabled for approximately 8 to 10 seconds.
  • By default, FEFD is disabled.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\