Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

fip-snooping port-mode fcf

Configure the port for bridge-to-FCF links.

Syntax
fip-snooping port-mode fcf

To disable the bridge-to-FCF link on a port, use the no fip-snooping port-mode fcf command.

Command Modes
INTERFACE
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S6100–ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0)
Introduced on the S3048-ON and S4048-ON.
9.7(0.0)
Introduced on the Z9500 and S6000-ON.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
Usage Information
The maximum number of FCFs supported per FIP snooping-enabled VLAN is four.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\