Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

hardware forwarding-table mode

Select a mode to initialize the maximum scalability size for L2 MAC table or L3 Host table or L3 Route table.

Syntax
hardware forwarding-table mode {scaled-l3- hosts | scaled-l3-routes}
Parameters
scaled-l3–hosts
Enter the keywords scaled-l3–hosts to select the forwarding table mode for scaling l3 host entries.
scaled-l3–routes
Enter the keywords scaled-l3–routes to select the forwarding table mode for scaling l3 route entries.
Defaults
UFT mode 2
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell EMC Networking OS Command Line Reference Guide.

The following is a list of the Dell EMC Networking OS version history for this command.

Version
Description
9.10(0.0)
Introduced on the S6100-ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.7(0.0)
Introduced on the S6000, S6000-ON, and Z9500 switch..
Usage Information
This command takes effect only after reboot.
Related Commands
show hardware forwarding-table mode — displays the hardware forwarding table mode in the current boot and in the next boot.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\