Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

hello-time

Set the time interval between generation of the spanning tree bridge protocol data units (BPDUs).

Syntax
hello-time seconds

To return to the default value, use the no hello-time command.

Parameters
seconds
Enter a number as the time interval between transmission of BPDUs. The range is from 1 to 10. The default is 2 seconds.
Defaults
2 seconds
Command Modes
SPANNING TREE
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.7.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
6.2.1.1
Introduced on the E-Series.
Related Commands
  • forward-delay — changes the wait time before STP transitions to the Forwarding state.
  • max-age — changes the wait time before STP refreshes protocol configuration information.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\