Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

ip mirror-access-group

Assign an IP mirror access control to an interface.

Syntax

ip mirror-access-group access-list-name {in} [implicit-permit] [vlan vlan-id] [optimized]

To remove an IP mirror-access-group configuration, use the no ip mirror-access-group access-list-name {in | out} [implicit-permit] [vlan vlan-id] [optimized] command.

Parameters
access-list-name
Enter the name of a configured access list, up to 140 characters.
in
Enter the keyword in to apply the ACL to incoming traffic.
implicit-permit
(OPTIONAL) Enter the keyword implicit-permit to change the default action of the ACL from implicit-deny to implicit-permit (that is, if the traffic does not match the filters in the ACL, the traffic is permitted instead of dropped).
vlan vlan-id
(OPTIONAL) Enter the keyword vlan then the ID numbers of the VLANs. The range is from 1 to 4094 (you can use IDs from 1 to 4094).
optimized
(OPTIONAL) Enter the keyword optimized to enable ACL optimization.
Defaults
Not enabled.
Command Modes
INTERFACE
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command-Line Reference Guide.

Version
Description
9.11(0.0)
Introduced on the S4048–ON, S4048T–ON, S6000, S6000–ON, S6010–ON, S6100–ON, Z9100–ON, and Z9500.
Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\