Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

ip pim neighbor-filter

To prevent a router from participating in protocol independent multicast (PIM), configure this feature.

Syntax
ip pim [vrf vrf-name] neighbor-filter {access-list}

To remove the restriction, use the no ip pim [vrf vrf-name] neighbor-filter {access-list} command.

Parameters
vrf vrf-name
(OPTIONAL) Enter the keyword vrf followed by the name of the VRF to prevent that VRF from participating in PIM.
NOTE: Applies to specific VRF if input is provided, else applies to default VRF.
access-list
Enter the name of a standard access list. Maximum 16 characters.
Defaults
none
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Added support for VRF. Introduced on the S6000-ON.
9.5(0.1)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.1.1.0
Introduced on the E-Series.
7.8.1.0
Introduced on the C-Series and S-Series.
7.6.1.0
Introduced on the E-Series.
Usage Information
Do not enter this command before creating the access-list.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\