Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

logging version

Displays syslog messages in a RFC 3164 or RFC 5424 format.

Syntax
logging version {0|1}
Defaults
0
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.5(0.1)
Introduced on the Z9500.
9.5(0.0)
Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
Usage Information

To display syslog messages in a RFC 3164 or RFC 5424 format, use the log version command in configuration mode. By default, the system log version is set to 0.

The following describes the two supported log messages formats:

  • 0 – Displays syslog messages format as described in RFC 3164, The BSD syslog Protocol

  • 1 – Displays SYSLOG message format as described in RFC 5424, The Syslog Protocol

Example
DellEMC(conf)#logging version ?
<0-1> Select syslog version (default = 0) 
DellEMC(conf)#logging version 1

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\