Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

mac-address-table station-move threshold

Change the frequency with which the MAC address station-move trap is sent after a MAC address changes in a VLAN. A trap is sent if a station move is detected above a threshold number of times in a given interval.

Syntax
[no] mac-address-table station-move threshold number interval count
Parameters
threshold number
Enter the keyword threshold then the number of times MAC addresses in VLANs can change before an SNMP trap is sent. The range is from 1 to 10.
interval seconds
Enter the keyword interval then the number of seconds. The range is from 5 to 60.
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0)
Introduced on the S3048-ON and S4048-ON.
8.3.19.0
Introduced on the S4820T.
8.3.7.0
Introduced on the S4810.
7.5.1.0
Introduced on the C-Series.
pre-6.2.1.1
Introduced on the E-Series.
Usage Information
For information about the specific trap sent and the corresponding Syslog, see SNMP Traps.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\