Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

match ip vlan

Uses a VLAN as the match criterion for an L3 class map.

Syntax
[seq sequence number] match ip vlan vlan-idTo remove VLAN as the match criterion, use the no [seq sequence number] match ip vlan vlan-id command.
Parameters
seq sequence number
(OPTIONAL) Enter the keyword seq then the sequence number. The range is from 1 to 100. By default, the sequence number are assigned in multiples of five.
vlan vlan-id
Enter the keyword vlan and then the ID of the VLAN. The range is from 1 to 4094.
Defaults
None.
Command Modes
CONF-CLASS-MAP
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.12(0.0)
Introduced the seq option for the class-map on all the Dell EMC Networking OS platforms.
9.10(0.0)
Introduced on the S3148.
9.8(2.0)
Introduced on the S3100 series.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.5(0.1)
Introduced on the Z9500.
9.4.(0.0)
Introduced on the S-Series and Z-Series.
Usage Information
To access this command, enter the class-map command. After the class map is identified, you can configure the match criteria.

Use this command to match an IP class-map against a single VLAN ID .

Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\