Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

match mac dot1p

Configure a match criterion for a class map based on a dot1p value.

Syntax
[seq sequence number] match mac dot1p {dot1p-list}
Parameters
seq sequence number
(OPTIONAL) Enter the keyword seq then the sequence number. The range is from 1 to 100. By default, the sequence number are assigned in multiples of five.
dot1p-list
Enter a dot1p value. The range is from 0 to 7.
Defaults
none
Command Modes
CLASS-MAP
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.12(0.0)
Introduced the seq option for the class-map on all the Dell EMC Networking OS platforms.
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.2.1.0
Available on the C-Series and S-Series.
7.5.1.0
Added support for the DSCP Marking option.
7.4.1.0
Introduced on the E-Series.
Usage Information
To access this command, enter the class-map command. After the class map is identified, you can configure the match criteria.
Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\