Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

monitor multicast-queue

Configure monitor QoS multicast queue ID.

Syntax
monitor multicast-queue queue-id

To remove the configuration, use the no monitor multicast-queue command.

Parameters
queue-id
Enter the QoS multicast queue ID. The range is from 0 to 9.
Defaults

queue-id: 0

Enable status: Disabled

Command Modes
CONFIGURATION
Example
DellEMC(conf)#monitor multicast-queue 7
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell EMC Networking OS Command Line Reference Guide.

The following is a list of the Dell EMC Networking OS version history for this command.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.8(0.0)
Introduced on the S6000, Z9500, S6000-ON.
Related Commands
show running-config monitor session — displays information about monitor configurations.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\