Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

neighbor add-path

This command allows the specified neighbor/peer group to send/receive multiple path advertisements.

Syntax
neighbor [ip-address | peer-group-name] add-path [send | receive | both] path-count
Parameters
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
(OPTIONAL) Enter the name of the peer group.
send
Enter the keyword send to indicate that the system sends multiple paths to peers.
receive
Enter the keyword receive to indicate that the system accepts multiple paths from peers.
both
Enter the keyword both to indicate that the system sends and accepts multiple paths from peers.
path-count
Enter the number paths supported. The range is from 2 to 64.
Defaults
none
Command Modes
CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000–ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.8.0
Introduced on the S4810.
Related Commands
  • bgp add-path — allow the advertisement of multiple paths for the same address prefix without the new paths implicitly replacing any previous ones.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\