Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

To return to the default setting, use the no neighbor {ip-address | peer-group-name} next-hop-self [all] command.

ip-address

Enter the IP address of the neighbor in dotted decimal format.

peer-group-name

Enter the name of the peer group.

all

Specifies that the route reflector is the next hop for both iBGP and eBGP-learned routes.

Version

Description

9.10(0.0)

Introduced the all keyword on the S4810, S4820, S4048–ON, S3048–ON, S3100 series, S6010–ON, S4040T-ON, S5000, S6000, S6000–ON, S6100–ON, Z9100–ON, and Z9500.

9.2(1.0)

Introduced on the Z9500.

9.0.2.0

Introduced on the S6000.

8.3.7.0

Introduced on the S4810.

7.8.1.0

Introduced on the S-Series.

7.7.1.0

Introduced on the C-Series.

If you configure the set next-hop command in ROUTE-MAP mode, the configuration takes precedence over the neighbor next-hop-self command.

If you do not use the all keyword, the next hop of only eBGP-learned routes is updated by the route reflector. If you use the all keyword, the next hop of both eBGP- and iBGP-learned routes are updated by the route reflector.