Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

neighbor soft-reconfiguration inbound

Enable a BGP soft-reconfiguration and start storing updates for inbound IPv6 unicast routes.

Syntax
neighbor {ipv4-address | ipv6-address | peer-group-name} soft-reconfiguration inbound
Parameters
ipv4-address | ipv6-address
Enter the IP address of the neighbor for which you want to start storing inbound routing updates.
peer-group-name
Enter the name of the peer group for which you want to start storing inbound routing updates.
Defaults
Disabled.
Command Modes
ROUTER BGPv6 ADDRESS FAMILY (conf-router_bgpv6_af)
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
8.4.1.0
Added support for IPv4 multicast and IPv4 unicast address families.
8.3.19.0
Introduced on the S4820T.
7.8.1.0
Introduced on the S4810.
7.7.1.0
Introduced on the C-Series.
7.4.1.0
Introduced
Usage Information
This command enables soft-reconfiguration for the specified BGP neighbor. BGP stores all updates for inbound IPv6 unicast routes the neighbor receives but does not reset the peer-session.
CAUTION: Inbound update storage is a memory-intensive operation. The entire BGP update database from the neighbor is stored in memory regardless of the inbound policy results applied on the neighbor.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\