Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

neighbor timers extended

Set idle hold time for a BGP neighbor or a peer group.

Syntax
neighbor {ip-address | ipv6-address | peer-group-name} timers extended idle holdtime

To return to the default values, use the no neighbor {ip-address | ipv6-address | peer-group-name} timers extended idle holdtime command.

Parameters
ip-address
Enter the IP address of the peer router in dotted decimal format.
ipv6-address
Enter the IPv6 address of the peer router in X:X:X:X::X format.
peer-group-name
Enter the name of the peer group to set the timers for all routers within the peer group.
timers extended idle holdtime
Enter a number for the time interval, in seconds, for the peer to be idle state. The range is from 1 to 32767. The default is 15 seconds.
Defaults

The default idle holdtime is 15 seconds.

Command Modes
ROUTER BGP
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.14(0.0)
Introduced on the C9010, MXL, FN IOM, S3100 series, S3048–ON, S4048–ON, S4048T-ON, S5048F-ON, S6000, S6010–ON, S6100–ON, Z9100–ON, and S6000–ON.
Usage Information

The peer remains in idle state based on the configured idle holdtime. The less the idle holdtime, less the peer in idle state.

For the new idle holdtime to take effect, you need to shutdown the respective peer manually using neighbor shutdown command and enable the peer again.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\