Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

no port-delay-restore (Interface Mode)

Disables delayed bring up of individual interfaces during switch boot up.

Syntax
no port-delay-restore
Parameters
None
Defaults
Enabled
Command Modes
INTERFACE
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command-Line Reference Guide.

Version
Description
9.14(2.3)
Introduced on the C9000, S3048-ON, S3100 series, S4048-ON, S4048T-ON, S5048F-ON, S6000, S6000-ON, S6010-ON, S6100-ON, and Z9100-ON.
Usage Information

To disable the timer on an individual interface, use the no port-delay-restore command.

To disable the timer on all ports globally, use the no port-delay-restore command in CONFIGURATION mode.

Related Commands
port-delay-restore (Interface Mode) — allows a delayed bring up of all interfaces during switch boot up.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\