Dell Command Line Reference Guide for the S4048–ON System


Object Tracking

Object Tracking supports IPv4 and IPv6, and is available on the Dell EMC Networking platforms.

Object tracking allows you to define objects of interest, monitor their state, and report to a client when a change in an object’s state occurs. The following tracked objects are supported:
  • Link status of Layer 2 interfaces
  • Routing status of Layer 3 interfaces (IPv4 and IPv6)
  • Reachability of IPv4 and IPv6 routes
  • Metric thresholds of IPv4 and IPv6 routes

You can configure client applications, such virtual router redundancy protocol (VRRP), to receive a notification when the state of a tracked object changes.

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\