Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

peer-routing-timeout

Configure the delay after which peer routing disables when the peer is unavailable. This command is applicable for both IPv6 and IPv4.

Syntax
peer-routing-timeout value

To restore the default value, use the no peer-routing-timeout command.

Parameters
value
Enter the timeout value (in seconds). The range is from 1 to 65535. The default value is infinity.
Command Modes
VLT DOMAIN (conf-vlt-domain)
Default
Infinity
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.7(0.0)
Added support for default value on the S-Series and Z-Series.
9.5(0.1)
Introduced on the Z9500.
9.4(0.0)
Added the support for IPV6 / IPV4.
9.2(0.2)
Introduced on the Z9000, S4810, and S4820T.
9.0.2.0
Introduced on the S6000.
Usage Information
When the timer expires, the software checks to see if the VLT peer is available. If the VLT peer is not available, peer-routing disables on that peer.

If you do not configure this delay value, peer-routing is not disabled even when the peer is unavailable.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\