Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

qos-policy-input

Create a QoS input policy on the router.

Syntax
qos-policy-input qos-policy-name cpu-qos | layer2

To remove an existing input QoS policy from the router, use the no qos-policy-input qos-policy-name cpu-qos | layer2 command.

Parameters
qos-policy-name
Enter the name for the policy map in character format (32 characters maximum).
cpu-qos
(OPTIONAL) Enter the keyword cpu-qos keyword to assign this ACL to control plane traffic only.
layer2
(OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class Map. The default is Layer 3.
Defaults
Layer 3
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.2.1.0
Policy name character limit increased from 16 to 32.
7.6.1.0
Introduced on the C-Series and S-Series.
7.5.1.0
Introduced on the C-Series.
6.1.1.1
Introduced on the E-Series.
Usage Information

Use this command to specify the name of the input QoS policy. Once input policy is specified, rate-police can be defined. This command enables the qos-policy-input configuration mode— (conf-qos-policy-in).

When changing a Service-Queue configuration in a QoS policy map, all QoS rules are deleted and re-added automatically to ensure that the order of the rules is maintained. As a result, the Matched Packets value shown in the show qos statistics command is reset.

If you create create a QoS input policy to be used for CoPP, you must enter the keyword cpu-qos .

Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\