Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

rate-limit

Configure NAS to allow or reject RADIUS dynamic authorization (DA) packets based on the configurable rate limit value.

Syntax
rate-limit packets per minute

To undo the configuration, enter the no rate-limit command.

Defaults
30 packets per minute.
Parameters
packet per minute
Enter the number of packets that you want processed per minute. The range is between 10 to 60 packets per minute.
Command Modes
  • CONF-DYNAMIC-AUTH
Usage Information
  • Packets are dropped after number of packets reaches the configured rate-limit.
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

The following is a list of the Dell EMC Networking OS version history for this command.

Version
Description
9.14(1.0)
Introduced on the S4810 and S4820T.
9.13(0.0)
Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000, S6010–ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and MXL.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\