Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

set

Mark outgoing traffic with a differentiated service code point (DSCP) or dot1p value.

S4048–ON

Syntax
set {ip-dscp value | mac-dot1p value}
Parameters
ip-dscp value
(OPTIONAL) Enter the keywords ip-dscp then the IP DSCP value. The range is from 0 to 63.
mac-dot1p value
Enter the keywords mac-dot1p then the dot1p value. The range is from 0 to 7.
Defaults
none
Command Modes
CONFIGURATION (conf-qos-policy-in)
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.2.1.0
Added mac-dot1p on the C-Series and S-Series.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
7.4.1.0
E-Series Only: Added support for mac-dot1p.
6.1.1.1
Introduced on the E-Series.
Usage Information

After the IP DSCP bit is set, other QoS services can then operate on the bit settings.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\