Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

sflow polling-interval (Global)

Set the sFlow polling interval at a global level.

Syntax
sflow polling-interval interval value

To return to the default, use the no sflow polling-interval interval command.

Parameters
interval value
Enter the interval value in seconds. The range is from 15 to 86400 seconds. The default is 20 seconds.
Defaults
20 seconds
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.2.1.0
Introduced on S-Series Stacking.
8.1.1.0
Introduced on the E-Series.
7.7.1.0
Introduced on the S-Series.
7.6.1.0
Introduced on the C-Series.
7.4.1.0
Introduced on the E-Series.
Usage Information
The polling interval for an interface is the maximum number of seconds between successive samples of counters sent to the collector. This command changes the global default counter polling (20 seconds) interval. You can configure an interface to use a different polling interval.
Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\