Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

show crypto ipsec policy

Display the crypto policy configuration.

Syntax
show crypto ipsec policy
Command Modes
EXEC
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.2(0.2)
Introduced on the Z9000, S4810, and S4820T.
9.2(1.0)
Introduced on the Z9500.
Example
DellEMC(conf-crypto-policy)# do show crypto ipsec policy

Policy name           : pol1
Policy refcount       : 0
Sequence Num          : 1
SA Mode               : IPSEC-MANUAL
Transform-Set Name    :
Peer IP Address       :
Inbound AH SPI        : 0
Inbound ESP Auth SPI  : 0
Inbound ESP Encry SPI : 0
Inbound AH Key        : [0]::
Inbound ESP Auth Key  : [0]::
Inbound ESP Encry Key : [0]::
Outbound AH SPI       : 0
Outbound ESP Auth SPI : 0
Outbound ESP Encry SPI: 0
Outound AH Key        : [0]::
Outound ESP Auth Key  : [0]::
Outound ESP Encry Key : [0]::


  Match sequence Num    : 2
  Protocol type         : tcp
  IP or IPv6            : IP
  Source address        : 1.1.1.1
  Source mask           : /32
  Source port           : 0
  Destination address   : 1.1.1.2
  Destination mask      : /32
  Destination port      : 23
  source-interface name :
  source-interface num  :

DellEMC(conf-crypto-policy)#

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\