Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

show fip-snooping enode

Display information on the ENodes in FIP-snooped sessions, including the ENode interface and MAC address, FCF MAC address, VLAN ID and FC-ID.

Syntax
show fip-snooping enode [enode-mac-address]
Parameters
enode-mac-address
Enter the MAC address of the ENodes to display.
Command Modes
  • EXEC
  • EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S6100–ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0)
Introduced on the S3048-ON and S4048-ON.
9.7(0.0)
Introduced on the Z9500 and S6000-ON.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
Usage Information
The following describes the show fip-snooping enode command shown in the following example.
Field
Description
ENode MAC
MAC address of the ENode.
ENode Interface
Slot/ port number of the interface connected to the ENode.
FCF MAC
MAC address of the FCF.
VLAN
VLAN ID number the session uses.
FC-ID
Fibre Channel session ID the FCF assigns.
Example
DellEMC# show fip-snooping enode
Enode MAC         Enode Interface FCF MAC           VLAN FC-ID
--------- --------------- ------- ---- -----
d4:ae:52:1b:e3:cd Te 1/11         54:7f:ee:37:34:40 100 62:00:11

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\