Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

show hardware forwarding-table mode

Display the hardware forwarding table mode in the current boot and in the next boot.

Syntax
show hardware forwarding-table mode
Defaults
none
Command Modes
EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell EMC Networking OS Command Line Reference Guide.

The following is a list of the Dell EMC Networking OS version history for this command.

Version
Description
9.10(0.0)
Introduced on the S6100-ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.7(0.0)
Introduced on the S6000, S6000-ON, and Z9500 switch.
Example
DellEMC#show hardware forwarding-table mode 

                     Current Settings            Next Boot Settings
Mode              :  Default                     scaled-l3-hosts
L2 MAC Entries    :  160K                         96K
L3 Host Entries   :  144K                        208K
L3 Route Entries  :   16K                         16K

DellEMC#
Related Commands
hardware forwarding-table mode — selects the mode to initialize the maximum scalability size for L2 MAC table or L3 Host table or L3 Route table.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\