Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

show ip pim snooping interface

Display information on VLAN interfaces with PIM-SM snooping enabled.

Syntax
show ip pim snooping interface [vlan vlan-id]
Parameters
vlan vlan-id
(OPTIONAL) Enter a VLAN ID to display information about a specified VLAN configured for PIM-SM snooping. The valid VLAN IDs range is from 1 to 4094.
Command Modes
  • EXEC
  • EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.5(0.1)
Introduced on the Z9500.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.4.1.1
Introduced on the E-Series.
Usage Information
The following describes the show ip pim snooping interface commands shown in the following example.
Field
Description
Interface
Displays the VLAN interfaces with PIM-SM snooping enabled.
Ver/Mode
Displays the PIM version number for each VLAN interface with PIM-SM snooping enabled:
  • v2 = PIM version 2
  • S = PIM Sparse mode
Nbr Count
Displays the number of neighbors learned through PIM-SM snooping on the interface.
DR Prio
Displays the Designated Router priority value configured on the interface (ip pim dr-priority command).
DR
Displays the IP address of the Designated Router for that interface.
Example (#2)
DellEMC# show ip pim snooping interface
Interface Ver Nbr    DR    DR
              Count  Prio
Vlan 2    v2  3      1     165.87.32.2
DellEMC#

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\