Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

show ip vrf

Displays information corresponding to the VRFs that you configure in the system.

Syntax
show ip [vrf vrf-name]
Parameters
vrf vrf-name
Enter the keyword vrf then the name of the VRF to display information corresponding to that VRF.
Command Modes
  • EXEC
  • EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.5(0.0)
Introduced on the Z9500.
9.4.(0.0)
Introduced on the S-Series and Z9000.
Example
DellEMC# show ip vrf
VRF-Name                    VRF-ID Interfaces

fault                       0       Te 1/1-13,18-47,
                                    Fo 1/49,50,51,52,
                                    Ma 1/1,
                                    Ma 2/1,
                                    Ma 3/1,
                                    Ma 4/1,
                                    Ma 5/1,
                                    Ma 6/1,
                                    
Nu 0,
                                    Vl 1
test1                       1       Te 1/14,16-17
test2                       2       Te 1/15
management                  64     



DellEMC# show ip vrf test1
VRF-Name                    VRF-ID Interfaces

test1                       1       Te 1/14,16-17

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\