Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

show ipv6 fib stack-unit

View all FIB entries.

Syntax
show ipv6 fib [vrf vrf-name] stack-unit unit-number [summary | ipv6-address]
Parameters
vrf vrf-name
(Optional) Enter the keyword vrf followed by the name of the VRF to display neighbors corresponding to that VRF.
slot-number
Enter the number of the stack unit.
summary
(OPTIONAL) Enter the keyword summary to view a summary of entries in IPv6 cam.
ipv6-address
Enter the IPv6 address in the x:x:x:x::x/n format to display networks that have more specific prefixes. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
Command Modes
  • EXEC
  • EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Added support for VRF.
9.0.0.0
Introduced on the Z9000.
8.3.19.0
Introduced on the S4820T.
8.3.7.0
Introduced on the S4810.
8.4.2.1
Introduced on the S-Series.
Usage Information
Host tables are not stored in CAM tables on S-Series platforms. Entries for camIndex displays as zero (0) on the show ipv6 fib stack-unit output for neighbor entries, such as address resolution protocol (ARP) entries.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\