Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

show running-config uplink-state-group

Display the current configuration of one or more uplink-state groups.

Syntax
show running-config uplink-state-group [group-id]
Parameters
group-id
Displays the current configuration of all uplink-state groups or a specified group. The valid group-id values are from 1 to 16.
Defaults
none
Command Modes
  • EXEC
  • EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10.0.2
Introduced on the Z9100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.10(0.0)
Introduced on the S3148.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.2(1.0)
Introduced on the Z9500.
9.2(0.0)
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux (PMUX) mode only.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.4.2.3
Introduced on the S-Series S50.
Example
DellEMC# show running-config uplink-state-group
!
no enable
uplink state track 1
downstream twentyFiveGigE 1/2,4,6,11-19
upstream FortyGigE 1/49, 29
upstream PortChannel 1
!
uplink state track 2
downstream twentyFiveGigE 1/1,3,5,7-10
upstream FortyGigE 1/49,42
Related Commands
  • show uplink-state-group — displays the status information on a specified uplink-state group or all groups.
  • uplink-state-group — creates an uplink-state group and enables the tracking of upstream links.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\