Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

show vxlan vxlan-instance physical-locator

Displays physical locators related to Network Virtualization Overlay (NVO) Gateway.

Syntax
show vxlan vxlan-instance instance ID physical—locator [vtep-ip A.B.C.D]
Parameters
instance ID
Enter the VXLAN instance ID. The platform supports only the instance ID 1 in the initial release.
A.B.C.D
Enter the IP address of the VTEP.
Defaults
Disabled
Command Modes
VXLAN INSTANCE
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.11(0.0)
Introduced the static mode on the S4048–ON, S4048T-ON, S6000–ON, S6010–ON, S6100–ON, and Z9100–ON.
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S6100–ON.
9.10(0.1P10)
Introduced on the Z9100–ON.
9.8(0.0)
Introduced on the S4048–ON.
9.7(0.0)
Introduced on the S6000-ON.
9.4.(0.0)
Introduced on the S6000.
Example
DellEMC#show vxlan vxlan-instance 1 physical-locator
Instance : 1
Tunnel   : count 1
    36.1.1.1 : vxlan_over_ipv4 (up)
Related Commands
vxlan-instance — Enable VXLAN Instance configuration on the platform.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\