Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

show vxlan vxlan-instance statistics interface

Displays the port VLAN statistics information related to Network Virtualization Overlay (NVO) Gateway.

Syntax
show vxlan vxlan-instance instance ID statisitics interface  interface  VLAN-ID
Parameters
instance ID
Enter the VXLAN instance ID. The platform supports only the instance ID 1 in the initial release.
interface
Enter the following keywords and the interface information:
  • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport[/subport] information.
  • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
  • For a Port Channel, enter the keywords port-channel.

VLAN-ID
Enter the VLAN ID.
Defaults
Disabled
Command Modes
  • EXEC

  • EXEC Privilege

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.11(0.0)
Introduced on the S4048–ON, S4048T-ON, S6000–ON, S6010–ON, S6100–ON, and Z9100–ON.
Example
DellEMC#show vxlan vxlan-instance 1 statistics interface fortyGigE 1/49 100

Port : Fo 1/49 Vlan : 100

Rx Packets : 13

Rx Bytes : 1317

Tx Packets : 13

Tx Bytes : 1321
Related Commands
vxlan-instance- Enable VXLAN Instance configuration on the platform.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\