Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

stack-unit provision

Preconfigure a logical stacking ID of a switch that joins the stack. This is an optional command that is executed on the management unit.

Syntax
stack-unit [stack-number] provision {model-identifier}
Parameters
stack-number
Enter a stack member identifier of the switch that you want to add to the stack.
model-identifier
Enter the model identifier of the switch to be added as a stack member. This identifier is also referred to as the provision type.
Defaults
When this value is not set, a switch joining the stack is given the next available sequential stack member identifier.
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.0)
Introduced on the S6100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.7.0
Introduced on the S4810.
8.3.11.1
Introduced on the Z9000.
Related Commands
  • reload – reboot the Dell EMC Networking OS.
  • show system – display the status of all stack members or a specific member.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\