Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

time-zone

Configure the time zone for contacting the person.

Syntax
time-zone zone +-HH:MM[start-time HH:MM] [end-time HH:MM]

To remove the time zone, use the no time-zone [zone | start-time | end-time] command.

Parameters
zone +-HH:MM
Enter the keyword zone then a time difference from GMT expressed as HH:MM. This number may be preceded by either a + or – sign.
start-time HH:MM
Enter the keywords start-time then a starting time expressed as HH:MM. Use the 24-hour clock format.
stop-time HH:MM
Enter the keywords stop-time then a stopping time expressed as HH:MM. Use the 24-hour clock format.
Command Modes
SUPPORTASSIST PERSON
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.11(0.0)
Introduced on the M I/O Aggregator and FN IOM.
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the C9010, Z9100–ON, S6100–ON, and S3100 series.
9.9(0.0)
Introduced on the S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000, S6000–ON, Z9500, MXL.
Usage Information
This command is optional for SupportAssist service configuration.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\