Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

track interface ipv6 routing

Configure object tracking on the routing status of an IPv6 Layer 3 interface.

Syntax
track object-id interface interface ipv6 routing

To return to the default setting, use the no track object-id command.

Parameters
object-id
Enter the ID number of the tracked object. The range is 1 to 500.
interface
Enter one of the following values:
  • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport[/subport] information.
  • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
  • For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
  • For a port channel interface, enter the keywords port-channel then a number.
  • For a tunnel interface, enter the keyword tunnel.
  • For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults
None
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
8.3.12.0
Introduced on the S4810.
8.4.1.0
Introduced.
Usage Information
Use this command to create an object that tracks the routing state of an IPv6 Layer 3 interface:
  • The status of the IPv6 interface is UP only if the Layer 2 status of the interface is UP and the interface has a valid IP address.
  • The Layer 3 status of an IPv6 interface goes DOWN when its Layer 2 status goes down (for a Layer 3 VLAN, all VLAN ports must be down) or the IP address is removed from the routing table.
Related Commands
  • show track ipv6 route – display information about tracked IPv6 routes, including configuration, current state, and clients which track the route.
  • track interface ip routing – configure object tracking on the routing status of an IPv4 Layer 3 interface.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\