Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

tunnel destination

Set a destination endpoint for the tunnel.

Syntax
tunnel destination {ip-address | ipv6–address}

To delete a tunnel destination address, use the no tunnel destination {ip-address | ipv6–address} command.

Parameters
ip-address
Enter the destination IPv4 address for the tunnel.
ipv6–address
Enter the destination IPv6 address for the tunnel.
Defaults
none
Command Modes
INTERFACE TUNNEL (conf-if-tu)
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.5(0.1)
Introduced on the Z9500.
9.3(0.0)
Introduced on the S4810, S4820T, S6000 and Z9000.
Usage Information

The tunnel interface is inoperable without a valid tunnel destination address for the configured Tunnel mode.

To establish a logical tunnel to the particular destination address, use the destination address of the outer tunnel header. If you configure a tunnel interface or source address, the tunnel destination must be compatible.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\