Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

tunnel flow-label

Configure the method to set the IPv6 flow label value in the outer tunnel header.

Syntax
tunnel flow-label value

To return to the default value of 0, use the no tunnel flow-label value command.

Parameters
value
Enter a value to set the IPv6 flow label value in the tunnel header. The range is from 0 to 1048575. The default value is 0.
Defaults
0 (Mapped original packet flow-label value to tunnel header flow-label value)
Command Modes
INTERFACE TUNNEL (conf-if-tu)
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.5(0.1)
Introduced on the Z9500.
9.3(0.0)
Introduced on the S6000, S4810, S4820T, Z9000.
Usage Information

This command is only valid for tunnel interfaces with an IPv6 outer header.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\