Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

tunnel source

Set a source address for the tunnel.

Syntax
tunnel source {ip-address | ipv6–address | interface-type-number | anylocal}

To delete the current tunnel source address, use the no tunnel source command.

Parameters
ip-address
Enter the source IPv4 address in A.B.C.D format.
ipv6–address
Enter the source IPv6 address in X:X:X:X::X format.
interface-type-number
  • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport[/subport] information.
  • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
  • For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
  • For a port-channel interface, enter the keywords port-channel then the port-channel ID.
anylocal

Enter the anylocal command to allow the multipoint receive-only tunnel to decapsulate tunnel packets destined to any local ip address.

Defaults
none
Command Modes
INTERFACE TUNNEL (conf-if-tu)
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.5(0.1)
Introduced on the Z9500.
9.4(0.0)
Added the tunnel source anylocal command.
9.3(0.0)
Introduced on the S4810, S4820T, S6000 and Z9000.
Usage Information

Added an optional keyword “anylocal” to the tunnel source command.  The anylocal argument can be used in place of the ip address or interface, but only with the multipoint receive-only mode tunnels. The tunnel source anylocal command allows the multipoint receive-only tunnel to decapsulate tunnel packets addressed to any IPv4 or IPv6 (depending on the tunnel mode) address configured on the switch that is operationally Up.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\