Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

vxlan-instance loopback

Provision VXLAN and non-VXLAN loopback ports that support routing in and out of VXLAN tunnels and enable MAC level loopback on all these ports.

Syntax
vxlan-instance instance ID loopback [port-channel id]
Parameters
instance ID
Enter the VXLAN instance ID. The platform supports only the instance ID 1.
port-channel id
(Optional) Enter the keyword port-channel and the port-channel ID to provision VXLAN and non-VXLAN loopback ports that support routing in and out of VXLAN tunnels.
Defaults
Disabled.
Command Modes
PORT CHANNEL CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.14(0.0)
Updated to enable MAC level loopback.
9.13(0.0)
Introduced on the S4048T-ON, S4048–ON, S6010–ON, S6000–ON, S6100–ON, S6000, and Z9100–ON.
Usage Information
You must configure VXLAN globally before using VXLAN-instance. Use the no shutdown command to enable the VXLAN instance.
Example

External Loopback:

DellEMC(conf-if-po-127)#sho c
!
interface Port-channel 127
 vxlan-instance 1 loopback 

Internal Loopback:

DellEMC(conf-if-te-1/2/2/3)#sho c
!
interface TenGigabitEthernet 1/2/2/3
 description connected IXIA card 1 port 14
 vxlan-instance 1 

Disable VXLAN Instance:

DellEMC(conf)#no vxlan-instance 1
Related Commands
feature vxlan — Enable VXLAN configuration globally on the platform.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\