S4048-ON Installation Guide January 2019

PDF

1U front-rack installation

You must configure the rails that are attached to the switch.

  1. Attach the inner chassis members switch rails to the S4048–ON switch. Item 3 shows the detail for the front standoff with the locking tab.
    Figure 1. Switch rails attachmentIllustration of attaching the switch rails.
  2. After you have installed both switch rails, line them up on the previously mounted Ready-Rails and slide the switch in until it is flush with front of rack. About 3 inches before you fully insert your switch, the rail locking feature engages to keep the switch from inadvertently sliding out of the rack and falling.
    • NOTE: Do not the use the mounted Ready-Rails as a shelf or a workplace.
    Figure 2. S4048-ON front-rack configuration Illustration of installing the S4048 in a front-rack configuration.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\