Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerSwitch S4048-ON Installation Guide February 2024

PDF

AC power supply installation

NOTE:The PSU slides into the slot smoothly. Do not force a PSU into a slot as this action may damage the PSU or the S4048–ON chassis.
NOTE:Ensure that you correctly install the PSU. When you install the PSU correctly, the power connector is on the right side of the PSU.
NOTE:If you use a single PSU, install a blank plate in the other PSU slot. If you are only using one power supply, Dell Technologies recommends installing the power supply in the first slot (PSU1) and installing a blank plate in the second slot (PSU2).
  1. Remove the PSU slot cover from the S4048-ON.
  2. Remove the PSU from the electro-static bag.
  3. Insert the PSU into the switch PSU slot. Insert the PSU exposed PCB edge connector first.
    The PSU slot is keyed so that the PSU can only be fully inserted in one orientation.
    Figure 1. PSU installation
    Illustration of installing the PSU.
    1. PSU
    2. Slot
    When you install the PSU correctly, it snaps into place and is flushed with the back of the switch.
  4. Plug in the appropriate AC three prong power cord from the switch PSU to the external power source.
  5. If you have a redundant PSU, a second PSU, repeat steps 1 through 4 above using the second PSU slot on the S4048-ON switch.
    NOTE:The S4048-ON powers up when the cables are connected between the power supply and the power source.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\