Dell EMC PowerSwitch S4048-ON Installation Guide March 2021

PDF

DC labels

Attach the DC rating labels to the S4048–ON Regulatory label on the bottom of the switch.

  1. Find the two DC power and DC input rating labels included with the DC power supply kit, as shown.
  2. Locate the regulatory label on the bottom of the switch.
  3. Attach the DC power label and input rating label over the AC power label and input rating label outlined in red, as shown.
    Figure 1. DC power label
    Illustration of the DC power label.
    Figure 2. DC input rating label
    Illustration of the DC input rating label.
    Figure 3. Switch regulatory label
    Illustration of the switch Regulatory Label

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\