S4048-ON Installation Guide January 2019

PDF

Four-post threaded configuration

  • CAUTION: To be NEBS Earthquake Z4-compliant, you must remove the tool-less latch castings described in Step 1.
  1. For this configuration, remove the latch castings from each end of the ReadyRails assemblies. To remove the two screws from each flange ear and remove each casting, use a Torx driver, item 1. Retain the castings for future rack requirements.
    Figure 1. Four-post threaded configurationIllustration of a four-post threaded configuration.
  2. For each rail, attach the front and rear flanges to the post flanges with two user-supplied screws at each end, item 2.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\