- Notes, Cautions, and Warnings
- About this guide
- The S4048–ON switch
- Site preparations
- NEBS compliance
- S4048–ON installation
- Power supplies
- Fans
- Management ports
- Specifications
- Chassis physical design
- IEEE standards
- Agency compliance
- Network Equipment Building Systems Compliance
- USA Federal Communications Commission Statement
- European Union EMC Directive Conformance Statement
- Japan VCCI Compliance for Class A Equipment
- Korean Certification of Compliance
- Safety Standards and Compliance Agency Certifications
- Electromagnetic Compatibility
- Product recycling and disposal
- Technical Support
Dell EMC PowerSwitch S4048-ON Installation Guide March 2021
S4048–ON installation
To install the S4048–ON switch, Dell EMC recommends completing the installation procedures in the order presented in this chapter.
Always handle
the S4048–ON and its components with care. Avoid dropping the switch
or its field replaceable units (FRUs).
NOTE: ESD damage
can occur if components are mishandled. Always wear an ESD-preventive
wrist or heel ground strap when handling the S4048–ON and its components.
As with all electrical devices of this type, take all the necessary
safety precautions to prevent injury when installing this switch.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\