S4048-ON Installation Guide January 2019

PDF

Micro USB-B console port access

The MicroUSB-B console port is on the I/O side of the switch.

The terminal settings are the same for the MicroUSB-B console port and the RS-232/RJ-45 console port:
  • 115200 baud rate
  • No parity
  • 8 data bits
  • 1 stop bit
  • No flow control

When you connect the Micro USB-B port, it becomes the primary connection and, while connected, all messages are sent to the Micro USB-B port.

  • NOTE: Before starting this procedure, be sure you have a terminal emulation program already installed on your PC. You need to install the appropriate drivers to support the Micro USB-B port. For assistance, contact www.dell.com/support to download the drivers.
  1. Power on the PC.
  2. Connect the USB-A end of cable into an available USB port on the PC.
  3. Connect the MicroUSB-B end of cable into the MicroUSB-B console port on the S4048-ON.
  4. Power on the S4048-ON.
  5. Install the necessary USB device drivers. To download the drivers, go to www.dell.com/support. For assistance, contact Dell EMC Technical Support.
  6. Open your terminal software emulation program to access the S4048-ON.
  7. Confirm that the terminal settings on your terminal software emulation program are as follows:
    • 115200 baud rate
    • No parity
    • 8 data bits
    • 1 stop bit
    • No flow control

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\